Features
- Convex dressing range: 0.8R-40R
- Concave dressing range: 0-40R
- Max. wheel dressing diameter: 250mm
- Max. wheel dressing diameter: 375 mm
- Positive setting of the diamond to absolute center with the special gage included with the dresser.
- Simple, fast,accurate radius setting; no height gage or other set-up aids required. Radius is set on the grinder by measuring over the two pins or by inserting a gage block, as shown, for direct reading. Inside or outside radius is determined simply by sliding the dowel pin to the right for concave and to the left for convex.
- 4X90° gaduation in full 360° circle. 6 Minute vernier reading. Chrome plated.
- One push-pull type knob for radius and angle control and for safer and faster operations.
- ACCURACY. Exteremely close tolerances are held in the manufacture of this tool, assured by hardening and precision grinding of all critical parts. Ways are chrome hardened.
- ECONOMY. Set-up and dressing time reduced to a bare minimum due to simplicity.
- Weight:11.5kgs
Features
- 6 minute vernier reading.
- 5-1/2″ long X 6-1/2″ high.
- Dual purpose knob for drum & angle movement.
- Stop for concave and convex radius.
- Comes with setting gage for diamond tool.
- R CONCAVE = 150 mm
- CINVEX = 60 mm
- MAX. Wheel Dia =279.4 mm
- Left & Right Stroke = 90 mm
- Weight: 12 kgs
Features
- No height gauge or set-up aids required.
- Radius is set on the grinder by measuring over the two pins or by inserting a gauge block for direct reading.
- Concave radius or convex radius is determined by using either the left or right hand pins.
- Radius = Set the DRESSER on surface grinder measuring by the 2 pins and / or inserting gauge block for direct reading.
- R CONCAVE = 100MM
- CONVEX =45 MM
- Left & Right Stroke = 65 mm
